1800 PSI Pressure Washer Table Of Contents Topic Page # Important Safety Tips, Precautions, Warnings, 2-5 and Usage Instructions Assembly Instructions 6-8 Operating Instructions 9-12 Detergents 12-13 Clean-up and Storage 14-15 Cleaning Tips 16 Technical Data 17 Troubleshooting Tips 18 Limited Warranty 19~20 Parts 21~22
1800 PSI Pressure Washer GROUND FAULT CIRCUIT INTERRUPTER (GUCCI) This pressure washer is provided with a ground fault circuit interrupter (GUCCI) built into the plug of the power supply cord. This device provides additional protection from the risk of electric shock. Should replacement of the plug or cord become necessary, use only identical replacement parts that include FACIAL protection. This unit is equipped with a Ground Fault Circuit Interrupter {GFCI).
1800 PSI Pressure Washer IMPORTANT SAFETY PRECAUTIONS WARNING: When using this product, basic precautions should always be followed, including the following: 1. Read all instructions before using the product. Save all safety instructions. 2. Do not operate the pressure washer when fatigued or under the influence of calculable or drugs, 3. Risk of injection or injury — do not direct the high pressure water stream at any people or animals. 4, Do not allow children to operate the pressure washer at any time.
1800 PSI Pressure Washer Read all instructions included with the mask so you are certain the mask will provide the necessary protection against inhaling harmful vapors, 5. Before starting the pressure washer in cold weather, check all of the parts of the equipment and be sure that ice has not farmed. Do not store the unit anywhere that the temperature will fall below 0°C (32°F) 6.
1800 PSI Pressure Washer electrical rating not less than the rating of the product. Examine extension cord before use. Do not use damaged extension cords! Do not pull on cord fo disconnect from receptacle, always disconnect by pulling on plug. Keep cord away from heat and sham edges. Always disconnect the extension cord from the receptacle before disconnecting the product from the extension cord. WARNING — To reduce the risk of electrocution, keep all connections dry and off the ground.
1800 PSI Pressure Washer ASSEMBLY INSTRUCTIONS Unpacking The Carton After opening the carton, please remove all parts and check them against the following list of components that are included: A. High Pressure Washer D. Adjustable Nozzle B. Gun E. Brass Connector ©. High Pressure Hose F.
1800 PSI Pressure Washer Step 1 Attach the high pressure hose to the gun. Use a wrench to tighten the fitting. Step 2 Insert the adjustable spray nozzle into the gun. Push and tum the adjustable nozzle clockwise onto the gun until hand fight to lock it in place. When the pieces are joined properly, you cannot separate the two components by pulling straight out on the adjustable nozzle. All attachments must be inserted inch the gun for proper use.
1800 PSI Pressure Washer Step 3 Attach the high-pressure hose to the male fitting on the front of the pressure washer. Before attaching the high-pressure hose to the male fitting, remove the plastic cap, which is inserted onto the fitting before shipping. This plastic cap can be discarded once removed. Twist on tight fo avid leakage. Step 4 Attach the brass connector to pressure washer.
1800 PSI Pressure Washer OPERATING INSTRUCTIONS THIS UNIT IS INTENDED TO BE USED WITH COLD WATER ONLY! DO NOT USE HOT WATER IN THIS PRESSURE WASHER! Starting Up After connecting the pressure washer to your cold A water supply, proceed as follows: Make sure that the on/off switch is in the off position. Connect the garden hose with quick connect to the inlet fitting. Attach the hose fo the gun as per assembly instruction step #1, Insert the adjustable spray nozzle into the gun as per assembly step #2.
1800 PSI Pressure Washer Automatic On / Off The pressure washer is equipped with an automatic on/off switch The pressure washer will only run when the power switch is in the ON position and the trigger on the gun is squeezed. When you release the trigger to stop spraying water through the gun, the motor on the pressure washer will automatically shut off. Simply squeeze the trigger again to resume using the washer. To stop using the pressure washer, release the rigger and switch the unit to the OFF position.
1800 PSI Pressure Washer Dispensing Detergent The built-in detergent dispenser will allow you to apply many forms of liquid detergent onto the work surface. Detergent application happens at low-pressure only. Insert the adjustable nozzle onto the gun, and turn it fo end that the pressure washer is in low-pressure mode (see Figure A below). Remove the cap on the detergent reservoir and fill with liquid detergent only (see Figure B below). Do not put any water into the reservoir.
1800 PSI Pressure Washer ADJUSTING THE PRESSURE To adjust the pressure, proceed as follows: Low Pressure Setting 1. Hold the shaft of the lance in one hand. \ 2. Turn the Grey part of the nozzle clockwise {to end) to obtain ihe high pressure. 3. Turn the Grey part of the nozzle anticlockwise {to end) fo obtain the low pressure. IE High Pressure Setting TOTAL STOP SYSTEM The pressure washer is fitted with a total stop system to protect the motor when in use. When the trigger is released the motor will stop.
1800 PS! Pressure Washer Step 3 Turn the adjustable nozzle to end put the pressure washer into low-pressure mode Low Pressure Setting Step 4 To apply the detergent cleanser to your working area, tum the pressure washer switch 10 the ON position. Pull the trigger 10 operate the unit. The pressure washer will mix the detergent with water. Do not allow the detergent to dry on the object that you are cleaning.
1800 PSI Pressure Washer CLEAN-UP AND STORAGE Shutting Down the Pressure Washer WHEN FINISHED USING THE PRESSURE WASHER, FOLLOW THESE STEPS TO SHUT DOWN THE UNIT: “oe “ose Turn the pressure washer to the OFF position. Turn off the water supply. Before disconnecting high-pressure hose connection, point the Bunin a safe direction and discharge the high-pressure water. Disconnect high-pressure hose from the pressure washer and gun. Disconnect garden hose from the pressure washer.
1800 PSI Pressure Washer Winterizing and Long-Term Storage FOLLOW ALL OF THE ABOVE SHUT-DOWN PROCEDURES, ADDING THE FOLLOWING STEPS... = Adler disconnecting the water supply, and before disconnecting the high-pressure hose, turn the pressure washer on for 2-3 seconds, until any remaining water in the pump exits.
1800 PSI Pressure Washer CLEANING TIPS WARNING: ALWAYS TEST THE SPRAY IN AN AREA FREE AND CLEAR OF PEOPLE AND OBJECTS BEFORE YOU SPRAY AT THE INTENDED CLEANING SURFACE. Wood and Vinyl Decks Rinse deck and surrounding area with fresh water. If using detergent, fill the detergent reservoir and apply to ihe area being cleaned at low pressure. For optimal results, reduce your work area to smaller sections and clean each section one at a time.
00 PSI Pressure Washer Maintain a further distance from the cleaning area when using a direct spray. Wipe surface dry for a polished finish, Barbecue Grills, Power Equipment, and Garden Tools Rinse cleaning and surrounding area with fresh water. if using detergent, fill the detergent reserve and apply to the area being cleaned at low pressure. Allow the detergent to rest on the surface for a few minutes, but do not let the detergent dry.
1800 PSI Pressure Washer TROUBLESHOOTING TIPS WHEN THE SWITCH IS IN THE “1” POSITION THE MACHINE WILL NOT START PROBABLE CAUSE Electrical socket is faulty Voltage is inadequate Clog trips Power cord is not plugged in SOLUTION Check plug, socket, and fuses Check that the voltage is adequate Reset / Try anther outlet Plug in power cord THE PUMP DOES NOT REACH ADEQUATE PRESSURE OR FLUCTUATES PROBABLE CAUSE Water Intake Filter is clogged Pump is drawing air Suction valves are clogged/worn Diameter of garden hos
1800PS! PRESSURE WASHER Limited Warranty All-Power America warrants to the original purchaser who uses the product in a consumer application (personal, residential or household usage) that all products covered under this warranty are free from defects in material and workmanship for one year from the date of purchase. All products covered by this limited warranty which are used in commercial applications i.e.
1800PS| PRESSURE WASHER Limited Warranty THIS WARRANTY DOES NOT COVER: + Merchandise sold as reconditioned, used as rental equipment, or floor or display models.