Instructions / Assembly

ManualsBrandsAll-Pro ManualsKitchenPrecision Plus Doppler Radar 270-Degree Outdoor Bronze Motion Activated Security Flood Light

Instruction Manual/Instrucciones

Questions?/¿Preguntas? 1-800-334-6871 ConsumerProducts@cooperlighting.com

•Donotallowsensorheadtotouchlighthousing–maintainatleast1/2inchspacebetween

 xtureandsensor.

•Iflensisreplaced,useonlytemperedsafetyglassofequalthickness.

•Forproperoperationandprotectionagainstdamage;themotionsensorheadadjustment

 knobsmustbefacingtheground.

•Donotusethisapparatusnearwater.

•Cleanonlywithadrycloth.

•Donotblockanyventilationopenings.Installinaccordancewiththemanufacturer’sinstructions.

•Donotinstallnearanyheatsourcessuchasradiators,heatregisters,stovesorother

 apparatus(includingampliers)thatproduceheat.

•Onlyuseattachments/accessoriesspeciedbythemanufacturer.

•ThisdevicecomplieswithPart15oftheFCCRules.Operationissubjecttothefollowingtwo

 conditions:(1)Thisdevicemaynotcauseharmfulinterference,and(2)thisdevicemust

 acceptanyinterferencereceived,includinginterferencethatmaycauseundesiredoperation.

 UnderPart15oftheFCCRules,anychangesormodicationstothemotiondetector

 describedinthisinstructionsheetthatarenotexpresslyapprovedbyCooperLighting,LLC

 couldvoidtheuser’sauthoritytooperatetheequipment.

NOTE:ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigital

device,pursuanttopart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonable

protectionagainstharmfulinterferenceinaresidentialinstallation.Thisequipmentgenerates,

usesandcanradiateradiofrequencyenergyandifnotinstalledandusedinaccordancewith

theinstructions,maycauseharmfulinterferencetoradiocommunications.However,thereis

noguaranteethatinterferencewillnotoccurinaparticularinstallation.Ifthisequipmentdoes

causeharmfulinterferencetoradioortelevisionreception,whichcanbedeterminedbyturning

theequipmentoffandon,theuserisencouragedtotrytocorrecttheinterferencebyoneor

moreofthefollowingmeasures:

 -Reorientorrelocatethereceivingantenna.

 -Increasetheseparationbetweentheequipmentandreceiver.

 -Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiver

  isconnected.

 -Consultthedealeroranexperiencedradio/TVtechnicianforhelp.

WARNING: FCC Regulations state that any unauthorized changes or modiﬁcations to this

equipment not expressly approved by the manufacturer could void the user’s authorization

to operate this equipment.

SAVE THESE INSTRUCTIONS.

FOR BEST RESULTS

•Installthemotionsensor/transmitter8-12feetabove

 ground(motionsensorislesssensitiveabove12feet).

•Locatemotionsensorsomotionmoveslaterallyor

 towardsthedetectionzone(Fig.1).

•Locatesensorawayfromheatproducingsourcesto

 preventfalsetriggering.Alsobeverycarefulnotto

 includeobjectssuchaswindows,whitewallsand

 waterinthedetectionzone.

•Locatextureawayfrommovingobjectssuchas

 trees,largeshrubsandstreettrafc.

•Donotinstallmorethanonemotionactivatedoodlightononewallswitch.

PACKAGING CONTENTS/CONTENIDO DEL PAQUETE

ITEMS REQUIRED

(Purchase separately)

•Phillipsscrewdriver

•Outdoorweatherproofsiliconecaulking

•(2)100watt(MAX)PAR38oodlightbulbs

NOTE:Thisxturewasdesignedtoworkwithupto150wattmaximumPARhalogenoodbulbs.

Forimprovedenergyefciency,lowerwattagePARhalogenoodbulbsmaybeused.Compact

Fluorescent(CFL)bulbscontainelectronicswhichmayinterferewiththemotionsensingfunction

ofyourxtureandarenotrecommended.TomeetENERGYSTAR

®

requirements,maximumlamp

wattagecannotexceed250watts.

HOW IT WORKS

PIRdoesagoodjobofdetectinglateralmotionacrossthe270°

rangeofdetection.PrecisionPlusDopplerRadar™doesan

excellentjobdetectingmotiontowardsandawayfromtheunit.

Bothsystemscombinedprovideenhancedaccuracyandcomplete

coveragewithinthedetectionrange.Motionfromanydirectionwill

triggeryouroodlight—evenduringhotorcoldtemperatureextremes.

WARNINGS AND CAUTIONS

•Readtheseinstructions.

•Keeptheseinstructions.

•Heedallwarnings.

•Followallinstructions.

•Foroutdooruseonly.

•cULusLISTEDforwetlocations.

•Connectxturetoa120volt,60Hzpowersource.Anyotherconnectionvoidsthewarranty.

•Fixtureshouldbeinstalledbypersonswithexperienceinhouseholdwiringorbyaqualied

 electrician.Theelectricalsystem,andthemethodofelectricallyconnectingthexturetoit,

 mustbeinaccordancewiththeNationalElectricalCodeandlocalbuildingcodes.

•Alwaysreplacebulbwiththesamewattageorlowerwattagethanmarked.Installingabulb

 ofahigherwattagecouldcreatearehazard.Useofahigherwattagebulbwillvoidthe

 warranty.(Maximum150watthalogenbulb.)TomeetENERGYSTAR

requirements,

 maximumlampwattagecannotexceed250watts.

•Keepawayfromammableobjects.Donotpositionxturewithinoneinch

 ofanycombustiblematerials.

•BulbgetsHOTquickly!

•Thebulbandxturegetextremelyhotduringuse.Disconnectpowerandallow

 xturetocoolbeforechangingbulborhandlingxture.

•Disassemblyofyourxturewillvoidthewarranty.

•Yourxtureispre-wiredandpre-assembledforeasyinstallation.

•Minimum90°Csupplyconductors.

•Fixturemountstoarecessedorsurfacemountedstandardgroundedjunctionboxmarked

 foruseinwetlocations.

MS276RD (Bronze)

MS276RDW (White)

A. Motion detector and light ﬁxture

Detector de movimiento y

artefacto de luz

ENGLISH

Upto

90feet

270degrees

Fig.1

D. Coverplate gasket

Junta de la placa

de cubierta

C. (2) #6 and (2) #8 mounting screws

(use the size that ﬁts your junction box)

(2) Tornillos #6 y (2) tornillos #8 de montaje

(utilice el tamaño que mejor se adecue

a su caja de conexión)

I. (2) Lampholder gaskets

(2) Juntas para portalámpara

E. (3) Wire nuts

(3) Tuercas para

alambre

B. Mounting bracket

Soporte de montaje

F. Mounting plate screw

Tornillo para la placa

de montaje

G. Color-matched

center hole plug

Tapón para agujero

central de color

coincidente

H. (2) Light covers

(2) Cubiertas de las luces

Summary of content (5 pages)

PAGE 1
Instruction Manual / Instrucciones Questions? / ¿Preguntas ? 1-800-334-6871 ConsumerProducts@cooperlighting.com PACKAGING CONTENTS/CONTENIDO DEL PAQUETE A. Motion detector and light fixture Detector de movimiento y artefacto de luz E. (3) Wire nuts (3) Tuercas para alambre B. Mounting bracket Soporte de montaje F. Mounting plate screw Tornillo para la placa de montaje MS276RD (Bronze) MS276RDW (White) G.
PAGE 2
MOUNTING YOUR FIXTURE NOTE: Universal coverplate mounts to recessed or surface mounted standard junction boxes (Fig. 2). Junction box must be at least 1-1/2˝ in depth for proper installation for recessed mount application. NOTE: For best performance when installing more than one Precision Plus Doppler Radar™ fixture: • Two or more units mounted side by side (facing the same direction) should be at least 17 feet apart. • Two units facing each other should be mounted at least 100 feet apart.
PAGE 3
Problem Cause / Solution Lights Stay On At Night And Do Not Turn Off There is motion in the detection zone. • Make sure the sensor is not picking up moving objects such as trees, traffic, etc. • Reduce the sensitivity. • Reposition the sensor. Unit is in override mode (if there is no motion). • Turn the light switch to the OFF position for 90 seconds, and then turn back to the ON postion. This will send the unit back into the motion activated setting “Auto”.
PAGE 4
6. Instale las cubiertas protectoras de las lámparas (H) en los portalámparas, alineando los niples de las cubiertas (H) sobre las ranuras de los portalámparas. Trabe las cubiertas en su lugar, haciéndolas girar en sentido antihorario (Fig. 7). 7. Inserte las juntas (I) en los portalámparas, y enrosque cada lámpara en su portalámpara correspondiente (Fig. 8). (No apriete las lámparas excesivamente.) 8. Active la fuente de alimentación en la caja de fusibles/interruptor automático.
PAGE 5
Modo de funcionamiento Adjuste de la perilla de MODO Como adjustar interruptor electrico Ajuste nocturno (activado sólo durante la noche) Las luces deben permanecer encendidas desde el atardecer hasta el amanecer y luego cambiar al ajuste de activación por movimiento al siguiente atardecer. La perilla de MODO apunta hacia una selección de tiempo entre el rango de tiempo de 1m-12m.