Instructions / Assembly

ENGLISH
3
Call for customer service and/or missing or damaged parts (800-334-6871)
• Always replace bulb with the same wattage or lower wattage than marked.
Installing a bulb of a higher wattage could create a fire hazard. Use of a
higher wattage bulb will void the warranty.
• Never touch the bulb with your bare hands, as oil from your skin can cause
premature failure. Always handle the bulb with gloves or a soft cloth.
• Disassembly of your fixture will void the warranty
• For supply connections, use wire rated at least 90° C.
• In the event of glass breakage, the entire lens cover must be replaced per UL
requirements. Contact Customer Service for ordering assistance.
Assembling your fixture
For eave mounting - Fig. 1.
For wall mounting - Fig. 2.
Note: This fixture has been preassembled for eave
mounting. Proceed to
Wiring your fixture listed on
page 4. For mounting to wall (Fig. 2):
Note: For use in wall mounted position, the lights
must be disassembled and reassembled to the
coverplate using the two additional threaded holes on
the coverplate.
Step 1: Unscrew both fixtures from eave mounting
position.
Note: Position fixture heads as shown (Fig. 3) to facilitate
ease of disassembly from coverplate.
Step 2: Unscrew the plugs from the coverplate
and screw the plugs into the eave mounting
position holes (Fig. 4). If plugs are stuck, tap
lightly to break paint seal.
Step 3: Thread the mounting arm from each light
into the two remaining mounting holes and
secure with the locknuts provided, using pliers.
Note: The locknut should be on the outside of the
coverplate.
Step 4: After securing both lights to the coverplate for wall
mounting, or to mount the fixture as packed in the eave mounting
position, follow instructions that follow.
Note: Bulbs come factory-installed within the two lamp heads.
Wiring your fixture
Note: This fixture should be mounted to a grounded junction box (not included).
Junction box must be at least 1-1/2˝ in depth for proper installation.
Step 1: Turn off the power at the main fuse/breaker box.
Step 2: Install the junction box mounting bracket using 2 of the 6-32 or
8-32 x 1/2˝ screws, depending upon the screw receptacles in
your junction box.
Fig. 3
Fig. 1
Fig. 2
Fig. 4
Use for
eave
mounting
Use for
wall
mounting
TMQ150_W 825-0138.qxd:TMQ150 325-1529.qxd 5/15/08 9:05 AM Page 3