AI 020220

Table Of Contents

Customer Service :(702)361-4345,(800)525-2655,customer.service@kalco.com

WARMING - TO REDUCE THE RISK OF FIRE OR INJURY:

1.lf you are unfamiliar with electricalwiring, call a qualified electrician to install this unit .More than

one person may be necessary to install fixture ,make sure you have enough qualified help.

2.Turn off the power to the fixture's circuit at the service panel. Use a coltage detector to verify that

the power is off.

3.DO NOT install bulb which exxeeds the maximum wattge specified on the socket label.

Step 1. Place mount mounting and wiring steps before

crystal installation step

Finally,check the installation,thecrystal hanging

on the iamp body.

Step 2.

Step 3.

Install E12 bulbs bulb,do not use

bulbs that exceeds 40W.

40W BULBS

Main body

ain body

Crystal

C20-16-06-01

Thread rod

Crystal tray

Rolling plate

Cone nut

020220-010-FR001 2-Light wall lam

PAGE 1
020220-010-FR001 2-Light wall lamp Customer Service :(702)361-4345,(800)525-2655,customer.service@kalco.com WARMING - TO REDUCE THE RISK OF FIRE OR INJURY: 1.lf you are unfamiliar with electricalwiring, call a qualified electrician to install this unit .More than one person may be necessary to install fixture ,make sure you have enough qualified help. 2.Turn off the power to the fixture's circuit at the service panel. Use a coltage detector to verify that the power is off. 3.
PAGE 2
020220-010-FR001 2-Light wall lamp Customer Service :(702)361-4345,(800)525-2655,customer.service@kalco.com Step 4. Fasten 2 (state specification of screw ) into mounting plate so that they extend away from wall when mounting plate is installed ELECTRICAL BOX MOUNTING BLOCK L Step 5. Attach the mounting plate to outlet box with sorews DECORATIVE NUTS N LAMP BODY Step 6. Refer to wiring diagram. Splice the ribbed side of fixture cord to the white supply wire from outlet box with wire connector.