AI 021040

WWW.ALLEGRICRYSTAL.COM
866.820.2665
P4
12-Loop
13-Center Stem
14-Connector
15-Distributor
16-Main Ring
17-Hex Nut x 2
18-Lock Ring
19-Washer
5-Canopy
11-Decorative Nuts
13-Center Stem
14-Connector
15-Distributor
16-Main Ring
MODEL 021040
OPTION-1 (PENDANT)
Step 1. Carefully unpack parts and lay them down on
a clean soft cloth for identification:
Step 2. Screw Center Stem 13 into connector 14
Step 3. Screw Loop 12 on top of center stem 13
Step 4. Hung fixture to chain 10 using the easy link 9
and Lace wires through every 3-4 chain links all the
way up. Release canopy by unscrewing collar loop
ring and pass wires through Nipple 3.
Step 5. Make wire connections as follows: This fixture
comes with a parallel wire, split wire and connect
fixture ribbed wire to power supply black wire,
connect fixture smooth wire to power supply white
wire, connect fixture bare copper or silver wire to
power supply green wire. Secure all connections with
black tape and wire nuts or as required by your local
electric code.
Step 6. Raise canopy and crystal bobeche flat to
ceiling and secure them with collar loop ring
Step7. Install crystal set as shown in page 5
OPTION-2 (SEMI-FLUSH)
Step 1. Carefully unpack parts and lay them down on
a clean soft cloth for identification:
Step 2. Screw Center Stem 13 into connector 14
Step 3. Pass Stem 13 through Canopy 5 and
Washer 19 and install two Hex Nuts 17 and Lock
Ring 18 on top of stem, tighteen Hex Nuts to prevent
fixture from turning
Step 3. Raise frame with canopy a few inches close to
ceiling and make wire connections as follows:
This fixture comes with parallel wire, split wire and
connect fixture ribbed wire to power supply black wire,
connect fixture smooth wire to power supply white wire,
connect fixture bare copper or silver wire to power
supply green wire. Secure all connections with black
tape and wire nuts or as required by your local electric
code.
Step 4. Align canopy holes with cross bar studs, push
canopy flat to ceiling and secure with decorative nuts11
Step 5. Install light bulbs (candelabra Krypton 40 watt
bulbs are recommended)
Step 6. Install crystals as shown in page 5.