Owner`s manual

REMOTE CO ALARM
WITH STROBE
The Remote CO Alarm System uses a 50’ cable to go
with workers into the work area and effectively warn
of the presence of carbon monoxide in the air source
with a 90 decibel alarm, along with a flashing strobe
light for those very noisy environments. The system is
housed in a rugged Pelican carry case or may be wall
mounted, and attached to any Allegro Air Filtration
Panel. Dimensions: 9.5"w x 8"d x 10"h
9871-01
ECONOMY REMOTE CO ALARM
WITH STROBE
Housed in a Pelican carry case with 25’ of cable, the
Economy CO Alarm has the same features as the
Remote CO Alarm with a smaller profile.
Dimensions: 8.5"w x 6.5"d x 5"h. Weight 2.6 lbs.
9871-01EC
POINT-OF-ATTACHMENT
AIR CONTROL SYSTEM
This Point-of-Attachment (POA) Air Control System
connects to any breathing air source. It’s housed in
a Pelican carry case that can be wall-mounted and
includes an adjustable pressure regulator, pressure
gauge and a pressure relief valve. This POA system
meets NIOSH requirements for point of attachment.
Maximum regulator inlet pressure is 150 psi.
9871-03
ECONOMY P.O.A.
Also offered in an economy model, with the same
features as our Point-of-Attachment Air Control
System without a Pelican carry case.
9871-03EC
02 MONITOR KIT
Calibration is a simple, automatic procedure. This
monitor is durable, reliable and water-resistant for on
the job flexibility. Features include a full function self
test sensor, battery status, easy on/off operation and
audible and visual alarms on start up. Bright, wide
angle visual alarm bars, confidence beep, automatic
backlight and automatic O2 calibration are all stan-
dard. Secure and accurate history with data logging
are also standard as well as a tamperproof setting
withpasscodeprotection.TheO2MonitorKitcanbe
attached to any Allegro Filtration Panel. Five language
choices are available (English, French, German,
Spanish and Portuguese).
9871-05
HIGH PRESSURE FILTRATION PANELS AND ACCESSORIES
REMOTE CO MONITOR
Attached to any air source or filter
panel, the Remote CO Monitor alerts
workers using supplied air respirators
when the level of carbon monoxide has
exceeded 10 ppm (5 ppm Canada).
The CO monitor can be operated in
AC or DC mode and uses a single 9-volt
alkaline battery. Maximum regulator
inlet pressure is 150 psi. Comes with
coupling pigtail.
9871-02
4-WORKER AIRLINE FILTER
Made for rugged environments, this “Pot” type filter utilizes a large capacity
quality filter cartridge to provide longer life. Greater material surface area
designed to remove oil, mist, water vapor and particulates down to 0.5 micron.
Made of impact and corrosion-resistant steel, equipped with an airline regulator
and four outlets. Wall or floor mounted. Meets OSHA regulation 1910-94 (6) (i)
and 1910-94 (6) (ii). 75 CFM
9874-W/O
When application requires CO monitoring the
Allegro Remote CO monitor can be attached to
the manifold. (Remote CO Monitor and
Airline Filter Sold Separately).
SOURCE PRE-FILTER
Where air quality is especially low,
this free-standing or wall-mounted
particulate assembly helps extend the
life of the filter panel’s disposable filters
by removing liquids and contaminates
down to 5 microns. It is equipped with
an adjustable regulator pressure gauge
and meets the NIOSH requirement for
point-of-attachment.
9350-03
respirators
24