Specifications

Replace lens cover when it becomes difficult to see through the lens. Replace hood when contaminant
penetration occurs, or when soiled or damaged. Clean the breathing tubes of the 9910 and 9910R outer
surface with mild soap and warm water. Rinse with clean water. Shake to remove excess water and let
air dry.
WARNING!
Do not allow the foam baffle inside the breathing tube to get wet. Do not use solvents to
clean any part of the hood.
WARNING!
DO NOT damage the lens with abrasive cleaners or pads.
REPAIR
Replacements are limited by the user to those components listed on the NIOSH label in this manual.
STORAGE
Store the Supplied Air Hood away from dust, sunlight, temperature extremes, moisture, and chemicals.
Before storing these hood assemblies, they should be inspected, repaired if necessary, cleaned, dried,
and given a final inspection. Only fully operable hood assemblies should be stored.
While in storage, the hood assemblies should be protected from distortion from the weight or pressure of
surrounding objects or being placed in too small a place.
SPECIFICATIONS
Weight: Complete Assembly 7.7 oz.
Replacement Hood 3.8 oz.
Material: Hood Assembly Poly Coated Tyvek
Saran Coated Tyvek
Breathing Tube Waist Belt Vinyl Hose Nylon Webbing
Air Consumption: 6 - 40 PSI @ 6 - 11 CFM
WARRANTY