User manual

Publication DNET-UM004A-EN-P - March 2004
2-8 Configure Your Network Offline
Configure the Scanner
To configure the scanner to communicate with the devices on your
network, you set up a scan list in the scanner. Then you define
memory locations for the data of each device.
To configure the scanner offline:
Scanner
Scan List
device at address 1
device at address 2
device at address 3
scan list – A list in the scanner that identifies the devices with which the
scanner communicates. For each device in its scan list, the scanner sets aside
input and/or output memory for the data of the device.
Output Memory
DINT Input Memory
0
device at address 1
1
2
device at address 2
3
4
device at address 3
5
Step: See page:
❑ Specify the Address of the Scanner 2-9
❑ Define the Properties of the Scanner 2-10
❑ Set the Alignment Option 2-11
❑ Clear or Set the Automap on Add Check Box 2-12
❑ Build the Scan List 2-13
❑ Manually Assign Each Device to a Memory Location 2-14
❑ Close the Configuration of the Scanner 2-15