User manual

Publication 1734-UM015A-EN-E - November 2009
18 Install POINT I/O DeviceLogix Modules
To install the mounting base assembly on the DIN rail, proceed as follows.
1. If you are using the 1734-TB or 1734-TBS mounting base, attach the
RTB to the mounting base.
Otherwise, skip to step 2.
2. Position the mounting base (wiring base assembly) vertically above the
installed units, for example, adapter, power supply, or existing module.
3. Slide the mounting base down, allowing the interlocking side pieces to
engage the adjacent module, power supply, or adapter.
4. Press firmly to seat the mounting base on the DIN rail until the base
snaps into place.
5. Use a small-bladed screwdriver to rotate the DIN-rail locking screw to
the horizontal position.
This locks the assembly to the DIN rail.
44858
Removable
Terminal Block
(RTB)
Mounting Base
31586