Installation manual

Frame 12 Installation 9-5
Figure 9.5 Enclosure Code H (NEMA/UL Type 12, IP54) and W (NEMA/UL Type 12,
IP54 w/Conformal Coat)
Lifting and Mounting Frame
12 Drives
Refer to Appendix B - Lifting and Mounting Instructions for detailed
instructions on lifting and mounting the drive. When you have completed
the instructions in Appendix B, continue with the installation as directed
below.
2403.5
198.5
478 478
(4.8)
1205.05
655.04
454
(94.6)
(7.8)
(18.8) (18.8)
(25.8)
(17.9)
87.9
(3.5)
116 (4.5)
Gap with
Overlapping
Plate Removed
57.2
(2.3) Standard
73.3 (2.9)
Max.
144.5
(5.7)
439
(17.3)
Dimensions are in millimeters and (inches).
NEMA/UL
Type 12 Roof
Assembly
NEMA/UL
Type 12
External
Filters
Stationary metal front bottom plate
Two pieces of soft foam taped to adjacent metal plates
Overlapping metal bottom plate (slightly adjustable)
Stationary metal back bottom plate
Wire entry for this enclosure is between two pieces of soft foam. If the adjustable plate is slid back, a gap
develops between the foam pieces. Otherwise, the foam acts as a loose gasket around the wires.