Installation manual

Lifting and Mounting Instructions B-9
Step 2: Removing the Skid and Shipping Feet for Frame 10 - 14 Enclosures
!
ATTENTION: To guard against personal injury and equipment
damage, do not work under the drive unless the drive is securely
mounted on appropriate blocks.
Task Description
Using a 15 mm wrench, remove the hardware that secures the drive to the skid.
Lift the drive off of the skid.
Place the drive on the proper blocks on a hard level surface.
The blocks should be approximately 10 cm (4 inches) high.
Using a 17 mm wrench, remove the hardware that secures the feet to the drive and
remove the feet.
A
A
A
A
B
A
C
A
C
D
A
B
C
A
A
C
D
D
D
Frames 10, 11, 13 and 14 (Frame 13 and 14 single enclosures only)
Frames 12, 13 and 14