Installation manual

Lifting and Mounting Instructions B-13
4. Complete the appropriate mounting procedures for Floor Mounting
(below) and/or Wall Mounting on page B-14
:
Floor Only Mounting
Secure the drive to the floor with anchor bolts in the front corner holes of
the enclosure base plate. Additionally secure the drive using the
mounting plates as needed (Rittal part no. 8800-210 or equivalent). Do
this as far back as possible to the choke assembly plate. With this method
the holes through base plate must be drilled on-site.
Important:If it is important to align the drive cabinet vertically with
adjacent Rittal cabinets, you may need to place shims under
the drive cabinet or use leveling feet throughout the cabinet
Task Description
Secure the roof assembly to the roof panel using the 16 washers and screws provided to .
Remove the two wing nuts that hold the handles in place, remove the two handles and
replace the wing nuts.
C
D
C
D
One roof assembly handle
shown for clarity only.