Installation manual

4-12 Control Wiring for PowerFlex 700S Drives with Phase II Control
Please note there are two separate values for an encoder.
Encoder Supply
Voltage
12V DC S2-4 12V DC 5V DC Change with Power Off
Set all switches the same
Encoder Signal A
Voltage
12V DC S2-1 12V DC 5V DC
Encoder Signal B
Voltage
12V DC S2-2 12V DC 5V DC
Encoder Signal Z
Voltage
12V DC S2-3 12V DC 5V DC
Function Down Switch Up Center Notes
DriveLogix
Processor
Run S1 Prog Remote Processor Mode
Function Default Switch Open Closed Notes