Installation manual

Frame 10 Installation 7-5
Figure 7.5 Enclosure Code H (NEMA/UL Type 12 - IP54) and W (NEMA/UL Type 12 -
IP54 w/Conformal Coat)
Lifting and Mounting Frame
10 Drives
Refer to Appendix B - Lifting and Mounting Instructions for detailed
instructions on lifting and mounting the drive. When you have completed
the instructions in Appendix B, continue with the installation as directed
below.
2403.5
198.5
478
655.04
454
606
(19)
(7.8)
(94.6)
(24)
(25.8)
(18)
116 (4.5)
Gap with
Overlapping
Plate Removed
57.2
(2.3)
Standard
73.3 (2.9)
Max.
144.5
(5.7)
439 (17.3)
83 (3.3)
NEMA/UL Type 12 Roof
Assembly w/Filters
NEMA/UL
Type 12
External
Filters
Dimensions are in millimeters and (inches).
Wire entry for this enclosure is between two pieces of soft foam. If the adjustable plate is slid back, a gap
develops between the foam pieces. Otherwise, the foam acts as a loose gasket around the wires.
Stationary metal front bottom plate
Two pieces of soft foam taped to adjacent metal plates
Overlapping metal bottom plate (slightly adjustable)
Stationary metal back bottom plate