Installation manual

Installing Your Mass Storage System
Chapter 3
39
Figure 1.10
How
to Connect the T winaxial Cable to the 1770M1 1 System
SERIAL CHANNEL J22
1SH2
IN
1SH2
OUT
11966
e. loosen three consecutive screws to one channel (either the IN or
OUT channel) of the 1770-M11 system
f. wrap the blue wire around the screw, labeled: 1; secure the screw
g. wrap the shield drain wire around the screw, labeled: SHIELD;
secure the screw
h. wrap the clear wire around the screw, labeled: 2; secure the screw
4. Select the communication rate by sliding the BAUD RATE switch to the
correct selection. (Refer to chapter 4 page 4-5.)
5. Plug the power cable into the power outlet.
If you need additional storage, you can connect up to three 1770-M10 systems
by performing these steps (Figure 1.11):