Installation manual
System Start-Up
Chapter 4
47
1. Select position 1 of the POWER switch. This initiates the following
indicator response:
POWER indicator lights green.
Micro-floppy drive indicator lights red for about 11 seconds.
Winchester drive indicator blinks once.
Micro-floppy drive indicator blinks once.
Both indicators remain off.
2. How the micro-floppy with the read/write access slot nearest the drive.
Make sure that the labels are facing up.
3. Gently, but firmly push the micro-floppy into the access slot until you hear
a click. The micro-floppy will seat into the access slot.
4. Press the RESTART pushbutton. You should see the micro-floppy
indicator blinking red, then the hard disk indicator blinking red. When
both indicators stop blinking, the operating system program is loaded into
the DMIM.
You can leave your mass storage system’s power on continuously. To reload the
operating system program start at step 4.
Refer to the Peripheral Communication Module User’s Manual, publication
1775-6.5.4 (formerly 1775-808) for information on creating a database.
After you’ve connected your mass storage system, you’re ready to begin
operations. Perform the following steps for your 1770-M12 system
(Figure 1.19):
System Startup procedure for
the 1770M12 System