Specifications

Publication GMC-SG001E-EN-P — June 2001
Motors 6-53
Wire Sizing Recommendations
The following section contains the wire sizing recommendations for the N-Series power, encoder and
brake connectors.
Connectors
1
Sizes are recommended minimum values for 4 conductors (U, V, W and GND).
Note: Wiring should be twisted, and local regulations should always be observed.
N-Series Motor Catalog Number
Note: Catalog numbers consist of various characters, each of which identifies a specific version or option
for that component. Use the catalog numbering table chart below to understand the configuration of
your motor. For questions regarding product availability, contact your Allen-Bradley distributor.
Motor
Power Connector
Motor
Encoder Connector
Motor
Brake Connector
Wire
1
mm
2
(AWG)
Wire
mm
2
(AWG)
Wire
mm
2
(AWG)
N-Series
1.5
2
(16)
N-Series
0.0804
2
(28)
1.5
2
(16)
N-Series
0.82
2
(18)
N - 42 14 - x - x 0 x xx
Factory Designated Special Options
AA = STANDARD
Options
00 = STANDARD
04 = 24V DC Brake
Optical Encoder Line Count
F = 1000 (STANDARD for 2300 Series)
H = 2000 (STANDARD)
K = 5000
Motor Winding Voltage
1 = 115V Drive Input Voltage
2 = 230V Drive Input Voltage
Continuous Torque Capability
NEMA Style Frame Size
Series Designator
N = NEMA Style Frame
Note: Optional configurations or encoder line counts have extended
lead times and additional charges
Note: Options are not available in all sizes.
Note: 5000-line count encoder, motor top speed is limited to 3600 rpm
due to frequency output limit of encoder. Check drive system
configuration data for any additional restrictions imposed by drive
input.