User manual

Chapter 2 Module Description
2-1
20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: [phone] Fax: [phone]
This chapter describes the physical layout of a Series 1700 module as well as
keyboard programming.
Front Panel Description
Program Switch
- (On other side of PC
Board, hidden from view.)
Used to
enable programming the module from the
keyboard. A two pin header next to the
switch can be removed to disable Program
Mode. The switch can also be disabled
from the processor.
Function Display
-
Used to display position
data and parameter values. The eight LED
indicators designate what is showing on the
display. When programming a parameter,
a blinking digit in the display shows the
position of the
Cursor
.
Status Indicators
- Indicates the operating
status of the module.
PRG -
Yellow light is on when the module is in
Program Mode.
RUN -
Green light is blinking when the module
is operating.
FAULT -
Red light is on when there is a module
fault. The type of fault is shown on
the display.
Keyboard
-
Used to examine position and
tachometer data as well as examine or
change the programming of the module.
Transducer Input Connector
-
Connector for
one to four transducers. A fourteen pin
connector is shown. The 1731, 1732,
1741, and 1742 modules have an eight pin
connector.
Figure 2.1 Series 1700 Front Panel