User manual

Chapter 2 Module Description
2-7
20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: [phone] Fax: [phone]
Transducer Setup Parameters (continued)
Circular Offset
Pg. 1-7
Default:0
Range:0 to (Scale Factor - 1)
Programming the Scale Factor parameter resets the
Circular Offset to zero.
Linear Offset
Pg. 1-7
Default:0
Range:0 to (9,999 - (Scale Factor - 1))
Programming the Scale Factor parameter resets the
Linear Offset to zero.
Preset Value
Pg. 1-7
Default:0
Range:0 to (Scale Factor -1)
Programming the Scale Factor parameter resets the
Preset Value to zero.
If the Linear Offset is not equal to zero, the new
position value will be (Linear Offset + Preset Value).
Module Setup Parameters
The following are the front panel displays of the module setup parameters along with default
values, range of values, and any special programming instructions. The page number given in the
heading is the page in chapter one that more fully describes the function of the parameter.
For all of these displays, the >▲@ and >▼@ keys change the entire value, not one digit. The >Æ@
and >Ç@ keys have no effect.
Data Format
Pg. 1-8
Default:Binary data format
Range:Binary
BCD
PLC SERIES
Figure 2.10 Circular
Offset
PLC SERIES
Figure 2.11 Linear
Offset
PLC SERIES
Figure 2.12 Preset
Value
PLC SERIES
Figure 2.13 Data
Format