User manual

About This Manual
I
20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: [phone] Fax: [phone]
Introduction
This manual explains the operation, installation, programming, and servicing of eight Series
1700 Intelligent Resolver Interface Modules for the Allen-Bradley 1771 I/O programmable
controller systems. These modules are the 1731, 1732, 1733, 1734, 1741, 1742, 1743, and
1744. The other four module in this series, the 1761, 1762, 1761-21, and 1763, are covered by
the following three manuals.
hýSeries 1760 Intelligent Resolver Interface Module User Manual
hý1761-21 Intelligent Resolver Interface Module User Manual
hý
1763 Intelligent Resolver Interface Module User Manual
It is strongly recommended that you read the following instructions. If there are any unan-
swered questions after reading this manual, call the factory. An applications engineer will be
available to assist you.
AMCI is a registered trademark of Advanced Micro Controls Inc.
The AMCI logo is a trademark of Advanced Micro Controls Inc.
PLC-2, PLC-3, and PLC-5 are registered trademarks of Allen-Bradley Company.
Viton is a registered trademark of E.I. DuPont
This product is licensed under patents and proprietary technology of Allen-Bradley
Company, Inc.. Allen-Bradley Company, Inc. does not warrant or support this product in any
manner.
Manuals at AMCI are constantly evolving entities. Your questions and comments on this
manual and the information it contains are both welcomed and necessary if this manual is to be
improved. Please direct all comments to: Technical Documentation, AMCI, 20 Gear Drive,
Plymouth Industrial Park, Terryville CT 06786, or fax us at [phone].
Revision Record
The following is the revision history for this manual. In addition to the information listed
here, revisions will fix any known typographical errors and clarification notes may be added.
This manual, 940-57011, supersedes 940-57010. It adds the outline drawings and
specifications of the H25-FL and H25-SL transducers and updates all other transducer and
cabling prints. This electronic manual corresponds to the printed version of the manual 940-
07011 and software version 8, checksum 1339 which is used on revision H+ of the main PC
board. This software revision incorporates several features into the standard products that were
only available as specialty options before. These new features are described in chapter 1:
Series 1700 Introduction. The hardware revision is a change over from through-hole to surface
mount components. Minor design enhancements were also included.
Past Revisions
940-57010: Original release of the manual. It was released in two parts, 57010A.pdf and
57010B.pdf.