User manual

Chapter 3 Installation
3-13
20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: [phone] Fax: [phone]
Autotech Transducer Installation
Transducer Mounting
Series 1700 modules support Autotech SAC-RL100, E6R and E7R-RL101, and SAC-
RL101-010 transducers. Refer to Autotech Controls literature for dimensional drawings and
mounting recommendations.
Even though Autotech transducers are usable, we strongly recommend using AMCI trans-
ducers whenever possible. Refer to the Autotech/AMCI cross reference table on page 1-5 for
information on our recommended replacements for Autotech transducers.
Transducer Wiring
Table 3.5 is a wiring table for all supported Autotech transducers. The table cross references
AMCI wire color, resolver designations, and Autotech connector pin-out.
AMCI
Wire Color
Resolver
Designations
SAC-RL101-010
Wire Color
SAC-RL100-010
Terminals
SAC-RL100-Gxxx
Terminals
Autotech
MS Conn.
BLK/RED
1
R1 RED/WHT
2
R1(RL) 1 F
RED R2 YEL/WHT
2
R2(RH) 2 E
WHT S1 RED S1 3 D
BLK/WHT
1
S3 BLK S3 4 C
BLK/GRN
1
S2 YEL S2 5 B
GRN S4 BLU S4 6 A
1: Denotes black wire of black and colored wire pair.
2: Denotes colored wire with white stripe.
Table 3.5 Autotech Transducer Wiring
Do not, under any circumstances, connect the shields of the transducer
cable to the earth ground connection of the transducer. This connection
may form a ground loop that could damage the 1700 module or PLC. The
earth ground connection on the MS style connectors is pin G. The earth
ground connection on the screw terminal transducers is a green screw.
Using AMCI and Autotech Transducers Together
If you are connecting
AMCI and Autotech
transducers to the same 1700
module, you must set the
resolver type parameter to
AMCI (resolver 1) and use a
RM-3 reference module to
adjust the reference to the
Autotech resolvers. The
figure below shows an outline
drawing and connection
diagram for a RM-3. The
RM-3 should be mounted as
close to the 1700’s transducer input connector as possible.
1 2 3
RM-3
1.4"
(36)
Max.
6-32 UNF x 0.30"
(7.6)
Long
Nut included with unit.
8
7
6
5
4
3
2
1
1
2
3
Module Connector
Mates with Transducer Input Connector
AMCI Part #: MS-8 or MS-14 (MS-8 shown)
To Autotech R2
To Autotech R1
RM-3 Reference Module
To AMCI MS-16 Connector Pin A
To AMCI MS-16 Connector Pin B
1.00"
(25.4)
dia.
Figure 3.20 RM-3 Outline Drawing and Wiring Diagram