User manual

Chapter 1 Series 1700 Introduction
1-5
20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: [phone] Fax: [phone]
Other Compatible Transducers
In addition to AMCI transducers, the 1700 modules directly support Autotech transducers.
The Autotech models supported are:
hý
All SAC-RL100 Transducers. (Size 40, NEMA 13)
hý
All E6R and E7R-RL101 Transducers. (Size 25, NEMA 13)
hý
SAC-RL101-010 Transducer. (Size 11, NEMA 1)
If your project is a new installation, or you can budget the cost of replacing the transducer,
we strongly suggest using AMCI transducers. AMCI is the only company in the marketplace
that designs and manufactures the resolvers used in its products. Our transducers and modules
are designed to work together, and when specified and installed properly will work for years to
come.
If your project involves converting system originally designed for Autotech products you
can most likely use AMCI transducers without re-designing transducer mounting brackets.
Table 1.3 lists Autotech transducer part numbers and the AMCI bolt-in replacements. Note
that the resolvers used in AMCI transducers are for AMCI products and all connectors are
AMCI standard connectors, unless otherwise stated.
Autotech
Transducer
AMCI
Transducer Comments
SAC-RL101-010 R11X-J10/7
Mechanically identical except that wires come out
the back instead of the side.
E6R-RL101-000EF
E7R-RL101-000EF
H25-FE Bolt-in replacement. Shorter body length.
E6R-RL101-000ES
E7R-RL101-000ES
H25-SE
Bolt-in replacement when servo mounting.
Different bolt pattern on front, shorter body.
E6R-RL101-000SF
E7R-RL101-000SF
H25-FS
Bolt-in replacement. Shorter body length, side
connector in different location.
E6R-RL101-000SS
E7R-RL101-000SS
H25-SS
Bolt-in replacement when servo mounting.
Different bolt pattern on front, shorter body
length, side connector in different location.
SAC-RL100-010 HT-400-1 Direct replacement.
SAC-RL100-M11
HT-400A-1
HT-400B-1
Direct replacement, Autotech connector.
Direct replacement, AMCI connector.
SAC-RL220-G010C HTT-400-1 Direct replacement.
SAC-RL220-G010M
HTT-400A-1
HTT-400B-1
Direct replacement, Autotech connector.
Direct replacement, AMCI connector.
Table 1.3 Autotech / AMCI Transducer Cross-reference
If you decide to use your Autotech transducers, you must change the Resolver Type
parameter from the keyboard or processor. The module then sets the reference voltage to
Autotech levels. If you set the Resolver Type to Autotech and you are using a multi-channel
module, then all of the transducers must be Autotech’s. If you wish to bring both types of
transducers into a single module, you must set the Resolver Type parameter to AMCI and use
an AMCI RM-3 Reference Module to connect the Autotech transducers. For more information
on using AMCI and Autotech transducer, refer to chapter 3, pg. 3-13, Using AMCI and
Autotech Transducers Together.