User manual

194 Publication ENET-UM001I-EN-P - January 2010
Appendix A Status Indicators
If the Module status indicator is flashing red, take the following
actions.
1. Complete firmware update.
2. Verify address switches.
If t
he Network status indicator is
off, take the following actions.
1. Apply power to device.
2. Verify, and correct, IP address, if necessary.
If t
he POINTBus status indicator is off, tak
e the following actions.
1. Apply power to device
2. Check module status indicator.
If t
he POINTBus status indicator is flashing
red, take the following
actions.
1. Configure the ch
assis size.
2. Check for missing module and reinstall, if necessar
y.
3. Check for I/O module failure and cor
rect, if necessary.
If the POINTBus status indicator is solid
red, take the following
actions.
1. Cycle power to device.
2. If condition persists, replace device.
If t
he System Power status indicator is off,
take the following actions.
1. Verify that power is on, and apply power if needed.
2. Verify backplane power has not been exceeded, and correct.
3. Replace 1734-AENT module.