User manual

Publication ENET-UM001I-EN-P - January 2010 49
Configure an EtherNet/IP Module to Operate on the Network Chapter 4
5. Click the Port Configuration tab.
6. For Network Configuration Type, select Static to permanently assign
t
his configuration to the port.
a. In the IP Address field, type the IP address.
b. In the Network Mask field, type the network mask address.
c. In the Gateway Address field, type the gateway address.
d. In the Primary Name Server field, type the name of the primary
ser
v
er.
e. In the Secondary Name Server field, type the name of the secondary
server.
f. In the Domain Name field, type the domain name.
g. In the Host Name field, type the host name.
7. Configure the port settings.
8. Cli
ck OK.
IMPORTANT
If you select Dynamic, on a power cycle, the controller
clears the current IP configuration and resumes sending
BOOTP requests.
To Then
Use the default port speed
and duplex settings
L
eave checked the Auto-negotiate port speed and
duplex check box.
Important: The default port speed is 100, a
nd the
default duplex setting is Full.
Manually configure your
port’s s
peed and duplex
settings.
a.Uncheck the Auto-negotiate port speed and
duple
x check box.
b. From the Current Port Speed pull-down menu,
select a port speed.
c
. From the Current Duplex pull-down menu,
choose Half Dup
lex.