Specifications

SLC 5/01 and SLC 5/02 Modular Processors 7
Publication 1747-IN011B-EN-P - September 2007
5. Close the processor door
Install the Processor into the Chassis
1. Turn off power to the chassis where you will insert the processor.
2. Align the circuit board of the processor with the card guide of slot 0 in the
1746 chassis.
3. Gently slide the processor in until both the top and bottom retainer clips are
secured.
4. Remove the protective wrap after installing the processor.
ATTENTION
Never install, remove, or wire any module while power is applied.
Also, do not expose processor modules to surfaces or other areas
that may typically hold an electrostatic discharge.
Electrostatic discharge can damage integrated circuits or
semiconductors if you touch backplane connector pins.
If the equipment is not installed and used as described in the SLC
500 Modular Hardware Style User Manual, publication
1747-UM011, the protection provided by the equipment may be
impaired.
Processor
Release
Card Guide
Protective Wrap
Power
Supply
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com