Instruction Manual

TAPE DECK INTERFACE

Your 21 series mixer is supplied with output levels and tape return

levels set for 0VU on meters =

4dBm

It is a very simple operation

to change operating levels to suit tape machines that require a

lower operating standard. The output levels from the stereo and mono

outputs and also the input level to the stereo tape input can all be

independantly adjusted.

Stand the mixer on rear panel,

ensuring safe and adequate support.

Remove bottom panel using POZI 2 screwdriver.

The illustration

above shows the positions of the level-match adjustors.

Simply

remove the adjustor link and replace the plastic plug the opposite

way round.

Make sure that

the plug is aligned with the pins on the

circuit board as you replace it.