Quick Start Guide

4. Installing Qu-SB
Free standing - For operating while on a stage
or other flat surface. Make sure the 4 rubber feet
are fitted.
 - Allow space around the unit for ventilation.
Run the cables to avoid a trip hazard.
The mixer should be transported in a purpose
designed padded bag or flight case.
Rack Mounted - For operating while fitted into
a 4U space in a standard 19” equipment rack or
flight case. The front panel is angled upwards to
allow easier access to plug in the cables. A gap
underneath the unit lets you feed cables through
from within the rack.
Rack mounting option kit QU-SB-RK19 is
available from Allen & Heath.
 - Ensure adequate air flow. Do not block the
rear ventilation slots or the gap underneath the
front of the unit.
To save space a ‘shallow’ case with internal depth
of 200mm (8”) or more is recommended.
Dimensions - Shown in millimetres (inches)
Fit the rack ears
(AA10262) to the mixer
using the 2x M4x8
(AB0332) screws per
side. Use a Torx T20
driver.
Secure Qu-SB into the
rack using the 2x M6x16
screws (AB10301) and
plastic cups (AB0345)
per side.
The rubber feet do not need to be
removed. If you do wish to remove them
then unscrew using a Torx T20 driver.
Rubber feet
Gap for ventilation and cables
161 (6.34") Free Standing
Angle
17 degrees
Rack Mounted
177
(17.32") Free Standing
(7.13")
(6.97") 4U Rack Space
436
162
483
(19") Rack Mounted
162
(6.38")
Angle
21 degrees
38
123
21