User guide

GL2000

SER

UIDE

AC mains supply = 100 to 110 V.AC 100 T 1.6A 20mm fuse

AC mains supply = 110 to 125 V.AC 120 T 1.6A 20mm fuse

AC mains supply = 210 to 230 V.AC 230 T 630mA 20mm fuse

AC mains supply = 235 to 260 V.AC 240 T 630mA 20mm fuse

CONNECTING AC MAINS TO THE CONSOLE

Refer to the SAFETY WARNING on the first page of this User Guide.

Mains input to the GL2000 is via a standard 3 pin IEC mains input connector. A mains cable with moulded mains

plug suitable for the local supply is supplied.

Check that the voltage indicated in the fuseholder window is the same

as the mains supply in your area.

For best performance it is important that the earth system is solid, clean and noise-free. To prevent mains born

and external interference pickup from lighting equipment, motors and other mains powered equipment it is

recommended that a separate 'clean' mains distribution outlet is used for the audio system.

All signal cables should have their screens connected to earth at the connector. If earth (ground) loop problems

result in audible hum or buzz then disconnect the cable screen connection at one end, usually the destination end.

This may be done within the cable plug or by operating the 'ground lift' switch if available on the connected

equipment. Many DI boxes and power amplifiers include this facility.

EARTHING THE AUDIO SYSTEM

The console chassis is connected to mains earth via the power cable. Audio 0V is connected internally to the chassis

and therefore mains earth. In this way all signal returns and connector shields are connected to mains earth at the

console.

To ensure operator safety do not remove the earth connection from

the AC mains plug.

To avoid the risk of fire replace the fuse only with the correct type and

value as specified on the unit.

It is normal for the power unit to dissipate heat. Ensure adequate

ventilation around the unit. Do not cover the unit or position it on soft

furnishings during operation.

Always switch the unit off before connecting or disconnecting the

console power cable.

This unit contains no user serviceable parts. Do not remove the

cover. Refer servicing to qualified service personnel only.