user manual

PL-6 User Guide AP5197 issue 4 1

Introduction The PL-6 is one of several remote control devices available for the iDR-4/8 audio mix processor

and iLive mixing systems. It is part of the Allen & Heath PL Series of wall plates and remote controllers. It can be

mounted into a plinth or custom furniture, or used free standing. A suitable template with cutting details is provided for

custom application. The PL-6 interfaces with the Allen & Heath PL-Anet serial port. Multiple PL-6 units can be daisy

chained together along with other PL-Anet devices using CAT5 cable. A terminator is provided for plugging into the

last unit in the chain. For information on the full range of PL products available visit http://www.allen-heath.com. The

PL-6 control and indicator functions are programmed using the iDR System Manager software, or the iLive Surface

TouchScreen or Editor software. Space is provided next to the controls for custom labelling. The PL-6 is ideal as a

remote mix controller, for example as a simple operator controlled fader panel in an installed sound system, or as a

personal musicians on-stage mix controller with in-ear monitors. The installer can program the unit according to the

requirements of the application, providing the degree of control needed by the day to day operator.

8 Faders can be configured individually for input, output, group or crosspoint level control or monitor level. Minimum

and maximum ranges can be set. 16 Switches, arranged as two per fader, can be configured as combinations of level

up/down, mute toggle, polarity toggle, audio monitor select, or preset recall. 24 LED indicators, arranged as three per

fader, can be configured as combinations of 3 colour signal meters, mute status, or preset related 3 colour LED

indication. Controls can be configured as unused if not required. A single 3 colour Status LED displays PL-Anet

power and communication status. Custom labels can be fitted into the recessed areas provided. Recommended

height is 6mm.

NOTE: Check the Allen & Heath web site for the latest version of iDR or iLive firmware and software:

www.allen-heath.com

This product complies with the European

Electromagnetic Compatibility directive 2004/108/EC.

NOTE: Any changes or modifications to the

equipment not approved by Allen & Heath could void

the compliance of the equipment. Whilst we believe

the information in this guide to be reliable we do not

assume responsibility for inaccuracies. We also reserve

the right to make changes in the interest of further

product development.

IMPORTANT :

Observe the local standards which may apply

to the installation regarding the grade of cable and

installation methods.

Do not install the equipment where it is

subject to moisture, heat, vibration or excessive

movement.

Connect this equipment to the Allen & Heath

PL-Anet port only. Test for correct wiring and

installation before switching the equipment on.

PL-6 Fader Remote AP5197

User Guide

PAGE 1
PL-6 Fader Remote AP5197 User Guide Introduction The PL-6 is one of several remote control devices available for the iDR-4/8 audio mix processor and iLive mixing systems. It is part of the Allen & Heath PL Series of wall plates and remote controllers. It can be mounted into a plinth or custom furniture, or used free standing. A suitable template with cutting details is provided for custom application. The PL-6 interfaces with the Allen & Heath PL-Anet serial port.
PAGE 2
Number of devices The maximum number of PL devices that can be connected depends on their type, cable lengths and PL-Anet Bus Speed. Up to 22x PL-6 devices may be connected in an iDR system with the half speed PL-Anet Bus setting. Fewer devices may be connected if long distances, full bus speed or other PL types are also involved. Long distances up to 300m (1000’), and star point connection are possible if the optional PL-9 PL-Anet hub is used.