Use and Care Guide

14 15

FINAL INSTALLATION

Lowes.com/allenandroth

9. Install bulbs (L) into sockets.

Note: This fan has an energy-saving wattage limiter

included. If you replace the candelabra-base bulbs with

over 190 watts, the light will automatically turn off. Please

ensure the bulb wattage is always below 190 watts.

10. Remove the preassembled rubber washer, hex nut,

11. Place glass bowl (K) on the preassembled pipe on light

kit (J)

pull chain through side hole on glass bowl (K). Make

sure pull chain hangs clear and is not tangled in light kit

(J) socket. Thread light kit pull chain through center

hole on glass bowl (K).

Note: Two people are recommended for this step.

Hex nut

Rubber washer

12. Place previously removed rubber washer and hex nut

(Step 10, page 14) onto the pipe and securely tighten.

Pass fan pull chain through side hole on bowl cap (M),

securely tighten.

13. Attach fan pull chain extension (BB) and light kit pull

chain extension (CC) to corresponding chains.

Assembly is now complete.

14. If you do not want to use the light kit (J), remove the

two connectors from the light kit (J), then remove the

preassembled hex nut and switch housing (I) from the

light kit (J).

Hardware Used

Fan Pull Chain Extension x 1

Light Pull Chain Extension

x 1

Hex nut

Connectors

Rubber washerHex nut