Installation Guide

1
Français p. 5
Español p. 9
ITEM #0165276/0270973
MODEL #20053-0501/20053-0516S2
TOWEL RING
Tools Required for Assembly (not included): Drill with 1/4-in. bit, Phillips screwdriver,
Small flathead screwdriver, Pencil
Estimated Assembly Time: 8 minutes
Before beginning the assembly of product, make sure all parts are present. Compare
parts with package content list and diagram above. If any part is missing or damaged,
do not attempt to assemble the product. Contact customer service for replace
ment parts.
PREPARATION
·
Use caution when drilling into walls to avoid drilling into electrical
and plumbing lines hidden within wall.
·
This item is not designed for use as a grab bar. Do not mount in locations
where product is likely to be used as a grab bar.
1
SAFETY INFORMATION
Description
Quantity
Part
PACKAGE CONTENTS
2
CAUTION
Helpful Tools (not included): Level
HARDWARE CONTENTS
Picture
A
2
Mounting Screw
Description
Quantity
Part
Mounting Bracket
Plastic Anchor
1
2
AA
BB
CC
Towel Ring
A
3
2. Center mounting bracket vertically in the
outline of post on towel ring . Mark location
of mounting screw holes. Drill the holes on
the wall with 1/4-in. bit (Fig. 2).
1. Position towel ring on wall where desired,
and lightly mark outline of the post on towel
ring with pencil (Fig. 1).
3. If mounting into stud, fasten mounting
bracket into wall with mounting screws
(Fig. 3).
4. If mounting into drywall, position plasti
c
anchors and drive into wall by using a
Phillips screwdriver. Fasten mounting
bracket to wall with mounting screw
(Fig. 4).
5. Place towel ring over mounting bracket
and tighten set screw on post of towel ring
with small flathead screwdriver (Fig. 5).
ASSEMBLY INSTRUCTIONS
Fig. 1
Fig. 2
Stud
Fig. 3
Drywall
Fig. 4
Fig. 5
Mounting Bracket
1
Hardware Used
2
Mounting Screw
A
A
A
A
CC
Mounting Bracket
1
Hardware Used
Hardware Used
Mounting Bracket
1
Hardware Used
Plastic Anchor
2
2
Mounting Screw
Mounting Bracket
1
AA
CC
CC
CC
AA
AA
CC
CC
AA
AA
CC
BB
BB
AA
AA
BB
CC
CC
CC
CC
A
A
4
REPLACEMENT PARTS LIST
LIFETIME LIMITED WARRANTY
Mounting Screw
Description
Part#
Part
Mounting Bracket
Plastic Anchor
Printed in China
RP50101
RP80115
RP80194
Picture
If this product fails due to a defect in materials or workmanship at any time during the life of the
product, the manufacturer will provide free of charge, at its sole option, replacement part(s) for
the product or a replacement product (or if product is no longer available, a comparable
product). This warranty does not cover products which have been abused, altered, damaged,
misused, cut or worn. This warranty does not cover, and the manufacturer is not liable for,
labor charges incurred and/or damages sustained during the course of the installation, repair
or replacement of any part(s) or product(s) provided under this warranty. This warranty is
non-transferrable. This manufacture disclaims all other implied or expressed warranties
including all warranties of merchantability and/or fitness for a particular purpose. As some
states do not allow exclusions or limitations on an implied warranty, the above exclusions and
limitations may not apply. This warranty gives you specific legal rights, and you may have
other rights that vary from state to state.
CARE AND MAINTENANCE
Clean with a soft, damp cloth only. DO NOT USE scrub pads, detergents or cleansers
as they may harm the protective finish of your bath accessories.
AA
BB
CC
A
For replacement parts, call our customer service department at 1-866-439-9800,
8 a.m. - 8 p.m., EST, Monday - Friday.
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at
1-866-439-9800, 8 a.m. - 8 p.m., EST, Monday - Friday.