Installation Guide

INSTALLATION INSTRUCTIONS (Continued)

7. To install the optional soap dispenser, unscrew the top of the

soap dispenser (D) from the plastic soap bottle and remove the

mounting nut (FF) and rubber gasket (EE). From above the sink,

insert the top of the soap dispenser into the fourth hole opening

in the sink. From underneath the sink, place the rubber

gasket (EE) onto the shank (7.1) on the soap dispenser (D)

and then thread the mounting nut (FF) onto the shank (7.1) to

secure the soap dispenser (D) to the sink.

8. From underneath the sink, screw the plastic soap bottle (8.1) onto

the soap dispenser shank (8.2).

CARE AND CLEANING

Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these

will dull the nish and void your warranty.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE SOLUTION

Faucet leaks

underneath handle.

Bonnet has come loose or

o-ring on cartridge is dirty or

twisted.

1. Move the handle to the OFF position. Unscrew the handle screw and remove

the handle.

2. Tighten the bonnet by turning it clockwise. Move the cartridge stem to the ON

position. The leak should stop draining out from around the cartridge stem.

3. If the leak does not stop, shut off the water supply. Remove the bonnet by

turning it counterclockwise. Lift out the cartridge valve. Inspect the larger

o-ring on the cartridge bonnet and the smaller o-ring on the cartridge stem.

Remove any debris from the o-rings. If either o-ring is twisted, straighten it. If

either o-ring is damaged, replace the cartridge by calling customer service.

4. Position the cartridge back into the faucet body. Make sure the ridges on the

two sides of the cartridge bonnet t into the grooves on the two sides of the

faucet body. Tightly screw the bonnet onto the faucet body.

5. Reinstall the handle.

8.1

8.2

7.1