Installation Guide

OPERATING INSTRUCTIONS (CONT’D)

Timer Function

• Press the TIMER ICON to set the countdown for the unit’s main power.

• If the unit is powered OFF, you can press the TIMER ICON to power ON the unit. The ember bed

will glow at the lowest brightness setting unless a different setting was saved in the memory.

• Press the TIMER ICON again to scroll through the timer settings, which are: 30, 1H, 2H, 3H, 4H,

5H, 6H, 7H, 8H, 9H, OFF. (30 means 30 minutes)

• When the timer reaches zero, it will turn OFF the main power and will maintain all the settings in

memory.

HEATER OVERRIDE

The power to the heater can be disengaged to prevent the heater from being accidentally or unintentionally

powered on. This feature is primarily added to help prevent children from powering on the heater when it is not

desired.

• To engage the heater override function press and hold the TEMPERATURE ICON for 10 seconds. The

symbol E3 will display and then go blank while beeping 3 times. The heater function is now locked. If

the TEMPERATURE ICON is pressed again E3 will appear then fade. The Flame, Downlight and Timer

functions will operate normally. Only the heater and blower are disengaged.

• To unlock the heater function, press and hold the TEMPERATURE ICON for 10 seconds. The symbol E3

will display and then go blank while beeping 3 times. The heater function is now engaged. By pressing the

TEMPERATURE ICON again you will be able to adjust the heat temperature to your desired temperature.

MEMORY FUNCTION

This unit has a memory function that allows you to turn off the MAIN POWER and retains all the other function

settings (excluding the TIMER function).

• When the unit’s main power is OFF, press the POWER ICON once on the insert control panel or on the

remote control to power the unit ON and “wake up” the individual function at the last setting. Press the icon

again to adjust it and press the main POWER ICON on the insert or on the remote control to turn the unit

OFF and save the new setting into memory.

• When the unit is powered ON, the LED readout will show the saved temperature setting. If a temperature

setting was not saved, it will show the ﬂame brightness setting saved in memory. If neither one has a setting

saved to memory, then only the ember bed will glow (as a power light indicator).

• To reset the memory, hold down the main POWER ICON for 10 seconds at any time. When this happens,

the LED readout will blink with three zeros three times the unit will be shut down.

• Another way to reset the memory is to unplug the unit from the wall.