Installation Guide

9
OPERATING INSTRUCTIONS
1. Remove the nial (E) and nial cap (F) to access
controls for motion activation.
When power is rst applied the light will initialize for 45
seconds and then will be in Test Mode. The Test Mode
will last for 5 minutes. The motion sensor adjustment
dials consist of two knobs to adjust Sensitivity and delay
Timer. During the Test Mode adjust the sensitivity to
the desired distance. After 5 minutes in Test Mode the
sensor will enter Auto Mode. Once in Auto Mode the
delay Timer can be set.
At night, you may manually override the Auto Mode on
the sensor to force the light to stay on until dawn. To
toggle the operation between Manual and Auto Modes:
• Toggle the wall switch o󰀨 for 2 seconds and then on
again.
• The sensor is more sensitive to motions across its
detection path rather than the motions directly towards
it. Walking with normal speed across the detection area
to set the desired detection distance properly.
• During initial setup, the light will come on for 5
seconds every time motion is detected.
• The sensitivity was set at the maximum 40 ft. at the
factory. By turning the knob counterclockwise, the
detection distance can be decreased down to 5 ft.
• The detection range covers approximately 120
degrees.
• Clean the sensor lens with soft cloth every 1 to 2
months to maintain sensitivity.
TEST MODE AUTO MODE
Mode Activation
When power is turned on, Test Mode
will start after 45 seconds.
When power is turned on, Auto
Mode will start after 5 minutes.
Works (Day/Night) Day and Night Night Only
Activated by
(Sensitivity knob)
Motion Motion
Detection Range
(mounted at 6.5 ft. high)
5-40 ft. 5-40 ft.
Shut o󰀨 delay
(Timer knob)
5 seconds 5 seconds - 3 minutes
1
Sensitivity
40 5ft 180 5 sec
Timer
D