Installation Guide

General Installation Instructions
allen + roth
Refer to the included hardware to determine which installation to follow
CAUTION : Drywall anchors are for drywall only. Use tile anchors for tile surfaces.
Tools Required for Assembly: (Not Included)
• Pencil • Hammer • Phillips head screwdriver and bit • Power drill
• 5/16 in. drill bit (drywall anchor) or 9/32 in. (molly bolt)
Helpful Tools: (Not Included)
• Level
• Safety glasses
Secure the end piece with
Allen wrench and set screw.
Place bracket over anchors and tighten screws firmly with Phillips
head screwdriver.
3
Drill 5/16 in pilot holes. Using a hammer tap drywall anchors flush
into the wall.
2
Insert the red push pin into the
drywall anchors until the wings
pop open. Then remove the pin.
Then center bracket and mark position of
the screw holes.
Outline the back plate.
1
Side View
Front View
Secure the end piece with
Allen wrench and set screw.
Place bracket over anchors and tighten screws firmly with Phillips
head screwdriver.
3
Drill 9/32 in. pilot holes. Using a hammer tap molly bolt anchors
flush into the wall.
2
9/32 in.
Then center bracket and mark position of
the screw holes.
Outline the back plate.
1
Side View
Front View
5 /16 in.
c.
a. b.
Toggle Anchor Installation Molly Bolt Anchor Installation
Use a power drill to tighten the
screws to collapse molly bolts
tightly to the wall.
Unscrew the screws from the
molly bolts.
2
1
1
2
Note: bracket designs may vary.