Installation Guide

Drawer Installation
To install drawers with Undermount Hidden Glides, extend each
drawer glide completely. Place the drawer on top of the extended
drawer glides. Slide the drawer squarely into cabinet on top of
drawer glides until you begin to feel resistance.
Push drawer evenly with moderate pressure until you hear the clips
snap into place. Pull drawer open to verify that both clips have
snapped into place. If you find that a clip is not in place remove the
drawer and repeat the installation procedure.
To install drawers with side-mounted drawer glides, place the
drawer in the cabinet opening, aligning the rollers on the track.
Push the drawer into the cabinet opening.
Drawer Glide Adjustments
Cycle the drawer open and closed to ensure that it operates
smoothly. If the drawer is not operating smoothly, be sure that
hooks on both of the drawer glides are engaged into the holes in
the back of the drawer. (Figure 26)
If the drawer still does not operate smoothly, open the drawer and
take a closer look at the drawer glides mounted inside the cabinet.
Slide the glides toward the center at the rear of the cabinet. Then
slide the drawer all the way in. This is usually all it takes to correct
the alignment and get a smoother glide. Adjust the back of the
glides by removing the drawer and sliding the back of the glide left
or right if more adjustment is necessary. (Figure 27)
Figure 27
Adjust glides
left or right as
required
Figure 26
Holes in the back
of drawer
Make sure hooks on drawer
glides are engaged into
holes on back of the drawer
Hook on drawer glides
Drawer Removal
To remove drawers with Undermount Hidden Glides, locate the
plastic clips on the bottom of the drawer. Grasp clips at the finger
points provided. Using moderate pressure squeeze the handles on
both sides, towards the outer edge of the drawer box. This pressure
should be maintained during drawer removal. While continuing to
squeeze the clips, pull the drawer straight out until it is removed
completely. (Figure 29)
To remove drawers with side-mounted drawer glides, pull the
drawer straight out until it stops. Then lift the front of the drawer
slightly and gently pull forward until the glides release.
Handy Pointers
Figure 28
Squeeze both clips
located under drawer
and pull drawer out
Base cabinet
15