Cleaning and Maintenance

Maintenance Instructions:
Unilin’s allen+roth laminate flooring is virtually maintenance-free. Routine
cleaning requires you only to vacuum, use a dust mop, or a very slightly damp
(not wet) mop and dry with a clean, white cotton cloth. The only product that
should be used to clean your floor on a regular basis is an alcohol-based laminate
floor cleaner or plain water. With its smooth surface, Unilin’s laminate flooring
cannot retain dust or dirt.
NEVER use shine enhancers/restorers, wax, polish, oil, or varnish coating on the
floor. Do not use soap or detergents, oil soaps, or one-step clean and shine type
products, or any product that squirts liquid directly on the floor. Do not use
products designated for wood flooring.
For dry maintenance, use a dust mop, microfiber mop, or vacuum cleaner. Use
only vacuum heads with soft bristles. Avoid vacuum attachments with ‘beater
bars’ or spinning heads, which could damage your floor. Ensure vacuum cleaner
wheels are not impregnated with grit; plastic wheels may scratch your floor.
For damp maintenance: Mist cleaning products (or plain water) lightly onto a dry,
soft cloth (never directly to the floor), wipe over floor. DO NOT allow floor to air
dry as this will leave a film on your floor. Use only a WELL WRUNG OUT
CLOTH. ALWAYS WIPE DRY IMMEDIATELY AFTER until no moisture is
visible on the floor.
WET MAINTENANCE WILL RUIN YOUR FLOOR. Never wet mop or use
steam cleaners on your floor.
Remove stubborn stains carefully with a little acetone (fingernail polish remover)
on a soft cloth. Never use steel wool, abrasive cleaners, or scouring powder, as
they will scratch your floor.
Unilin laminate is based on pre-treated, watertight, glued HDF board. Despite
Unilin laminate’s relative moisture-resistance, remove any excess water
immediately.

Summary of content (2 pages)