Installation Guide

4
Lowes.com/allenandroth
ASSEMBLY INSTRUCTIONS
Hardware Used
x 3Wire Connector
AA
2. Wire connection guide:
Ground wire:
• For installation in the United States: Wrap
ground wire from outlet box around ground
screw on mounting bracket (B) no less than 2
in. from wire end. Tighten ground screw. If
fixture is supplied with a ground wire,
connect to outlet ground wire with a wire
connector (AA).
• For installation in Canada: If fixture is
supplied with ground wire, wrap ground wire
around ground screw on mounting bracket
(B). Tighten ground screw.
Supply wires:
• Connect the Neutral (White) supply wire from
the outlet box to the Neutral fixture wire
(White or Parallel Cord “D” shaped and
ribbed).
• Connect the Hot (Black) supply wire from the
outlet box to the Hot fixture wire (Black or
Parallel Cord round and smooth).
NOTE:
Fixture wires will either be:
• Black and White.
• Parallel Cord SPT-2 lamp wire with one
round smooth wire and one “D” shaped
ribbed wire.
2
BARE COPPER,
OR GREEN
GROUND
SUPPLY WIRE
BARE COPPER,
OR GREEN
GROUND
FIXTURE
WIRE
BLACK FIXTURE
WIRE
OR
WHITE FIXTURE
WIRE
BLACK SUPPLY
WIRE
BLACK SUPPLY
WIRE
PARALLEL
FIXTURE CORD
(ROUND AND
SMOOTH)
PARALLEL FIXTURE
CORD (“D” SHAPED
AND RIDGED
)
WHITE SUPPLY
WIRE
WHITE SUPPLY
WIRE
AA
Hardware Used
Short Machine
Screw
x 2
BB
1. Orient mounting bracket (B) so the raised center
portion protrudes into the outlet box (not included).
Remove top hex nut (H) from threaded nipple (G)
and screw threaded nipple (G) into middle of
mounting bracket (B). Secure threaded nipple (G)
to mounting bracket (B) at the top with the removed
hex nut (H). Temporally pass canopy (A) over the
threaded nipple (G). Adjust threaded nipple (G)
until 1/4th of the threads are exposed past the
canopy (A). Remove the canopy (A) and screw
bottom hex nut (H) up the threaded nipple until it is
against the mounting bracket (B).
Finally, connect mounting bracket (B) to the outlet
box with short machine screws (BB).
1
Outlet
Box
B
BB
G
H
A