Installation Guide

Attach mounting strap (C) to outlet box (not

included) using existing washers and outlet box

screws or the machine screws (BB). NOTE: If the

outlet box screws required for your outlet box are

of a different size than the machine screws (BB),

consult a licensed electrician before proceeding.

Tighten machine screws (BB) to secure mounting

strap (C) to outlet box.

CAUTION: Make sure the outlet box can

support 35 lbs. hanging weight. Use metal outlet

box; plastic outlet boxes are not recommended.

ASSEMBLY INSTRUCTIONS

Outlet

Box

Remove existing fixture and disconnect all

electrical wiring.

Hardware Used

Machine Screw

x 2

Washer

BB BB

Outlet Box

If you wish to use the preassembled clips (E),

proceed to Step 5.

If you wish to use one of the sets of clips (E)

with an alternate finish, remove two short screws

(F) and one long screw (G) from inside of fixture

(A). Remove existing clips (E).

Install desired set of clips (E) with two short screws

(F) and one long screw (G).

NOTE: Attach one clip (E) at a time, holding each

clip (E) in place on the outside of the fixture (A),

facing down. Install screws (F and G) from the

inside of the fixture (A) to secure each clip (E).