welcoming • sophisticated • inspiring APPROVED FOR USE IN DAMP LOCATIONS allen + roth® is a registered trademark of LF, LLC. All Rights Reserved. ITEM #1448561 FLUSHMOUNT CEILING LIGHT MODEL #CLL13CH Français p. 10 Español p. 19 ATTACH YOUR RECEIPT HERE Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-866-439-9800, 8 a.m. - 8 p.m., EST, Monday - Sunday.
TABLE OF CONTENTS Package Contents ................................................................................................................2 Hardware Contents ...........................................................................................................................3 Safety Information ................................................................................................................3 Preparation ...........................................................................
HARDWARE CONTENTS (shown actual size) AA BB CC DD Wire Connector Machine Screw Shade tab Tab Screw Qty. 3 Qty. 2 Qty. 3 +1 extra Qty. 3 +1 extra EE Screwdriver Qty. 1 SAFETY INFORMATION READ AND SAVE THESE INSTRUCTIONS. DANGER • For your protection and safety, carefully read and understand the information provided in this manual completely before attempting to assemble, install or operate this product.
SAFETY INFORMATION WARNING • All electrical connections must be in agreement with local codes and ordinances, the National Electric Code (NEC) and ANSI/NFPA 70-1999. Contact your municipal building department to learn about your local codes, permits and/or inspections. Risk of fire - most dwellings built before 1985 have supply wire rated for 140°F. Consult a qualified electrician before installation.
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
ASSEMBLY INSTRUCTIONS 3. Remove light kit (A) from fixture (B) by removing 3 nuts (D) from top of light kit (A). Save nuts (D) for later use. 3 D D D A B 4. Insert machine screws (BB) two full turns into screw holes in the outlet box. NOTE: If the outlet box screws required for your outlet box are of a different size than the machine screws (BB), consult with a licensed electrician before proceeding.
ASSEMBLY INSTRUCTIONS 5a. Prepare wire by stripping 1/2 in. of insulation from wire ends using wire strippers (not included). Unwrap BARE wire from BLACK and WHITE wires. Connect WHITE wire from light kit (A) to WHITE wire from outlet box using existing wire connector or wire connector (AA). Connect BLACK wire from light kit (A) to BLACK wire from outlet box using existing wire connector or wire connector (AA).
ASSEMBLY INSTRUCTIONS 6. Align keyslot holes on light kit (A) with machine screws (BB) on outlet box and push up. Twist light kit (A) to secure to outlet box. Tighten machine screws (BB) completely to secure light kit (A). 6 Outlet Box BB BB A 7. Place glass shade (C) inside fixture (B) with smooth side down. Secure glass shade (C) by attaching shade tabs (CC) to posts with tab screws (DD) using the screwdriver (EE).
ASSEMBLY INSTRUCTIONS 8. Attach fixture (B) to light kit (A) aligning three screws on fixture (B) with three screw holes on light kit (A) and replace nuts (D) previously removed (step 3, page 6). Make sure nuts (D) are secure. 8 D D D A Restore power and test fixture. If fixture does not function, please refer to TROUBLESHOOTING below. B CARE AND MAINTENANCE • Shut off main power supply. Wipe fixture with soft cloth. Use window cleaner to clean glass.