Installation Guide
ASSEMBLY INSTRUCTIONS
Hardware Used
Hardware Used
1
2
3
4
Crossbar
x 1
x 3
x 2
4. Attach wire nuts (AA). Tape wire nuts (AA)
and wires together.
Wire nut
Cap nut
B
CC
B
B
AA
DD
AA
ASSEMBLY INSTRUCTIONS
5
6
6. Install bulbs (E).
2. Based on desired length, install short stems (B)
and stems (C) together. Then install one end of
stem assembly to î‚¿xture (D) and the other end to
ceiling plate (A).
Note: At least one short stem (B) or one stem (C)
must be used.
3. Strip 3/4 in. of insulation from wire ends. Twist
stripped ends together with pliers (not included),
black to black (power) and white to white (neutral).
Attach copper wire to ground wire.
Helpful hint: If necessary, attach copper ground
wire to grounded junction box.
4 5
5. Attach ceiling plate (A) to crossbar (CC).
Secure with cap nuts (DD).
DD
E
BB
CC
Hardware Used
Cap nut
Machine screw
Crossbar
x 2
x 2
x 1
1. Remove cap nuts (DD) from the preassembled
mounting screws on crossbar (CC). Attach
crossbar (CC) to the outlet box (not included) with
machine screws (BB). Note: The mounting screws
should protrude away from the outlet box.
B
DD
B
BB
B
CC
B
A
C
allenandroth.com allenandroth.com
D
CC
A
DD