Installation Guide

GFCI Wall

Outlet

WARNING: The power cord is equipped with

a three-prong grounded plug that must be

inserted into a matching receptacle. Under no

circumstances must the grounding prong be cut

off the plug. Where a two-prong wall receptacle is

encountered, it must be replaced with a properly

grounded three-prong receptacle installed in

accordance with the National Electrical Code and

all applicable local codes and ordinances.This

work must be done only by a qualified electrician,

using copper wire only.

Plug

Insert the power cord preassembled on fan

assembly (A) into proper wall outlet.

WARNING: If using this fan in a DAMP

location, this fan must be connected to a supply

circuit that is protected by a Ground Fault Circuit

Interrupter (GFCI) to reduce the risk of personal

injury, electrical shock or death.

Hook

Place hook at top of front cage (C) over edge at top

of back cage (E). Note: Make sure hook engages

with verticle rib and all front and back cage holes

match up; this will allow the front cage (C) and the

back cage (E) to hang together while you put the

front cage screw (BB) into the the front and back

cage holes.

Partially insert one front cage screw (BB) into the

hole in center at top of front cage (C), then partially

insert the rest of the front cage screws (BB). Tighten

front cage screws (BB) by alternating from one side

of front cage (C) to the other until all front cage

screws (BB) are completely secured.

12.

Front Cage Screw x 8

Hardware Used

Off

Lowes.com/harborbreeze

ASSEMBLY INSTRUCTIONS

13.