Installation Guide

Hex Coupling
Hardware Used
CC
x 1
Hardware Used
DD
x 1
6. Place the shade (D) into the cage (C). Lift the cage
(C) upward, passing the nipple on the bottom of the
fixture (B) through the center hole on the bottom bar
of the cage (C). Secure with hex coupling (CC). Hand
tighten until sung.
7. Screw the nipple (DD) into the hex coupling (CC).
Pass the cap (E) over the nipple (DD) and secure with
the finial (F). Tighten until snug.
Nipple
6
ASSEMBLY INSTRUCTIONS
8
6
7
Silicone Sealer
Outdoor Fixture
Backplate
Exterior Wall
Surface
8. Make sure exterior wall surface and fixture
backplate are free of dirt. Using silicone sealer,
start on one side of fixture backplate and follow
contour, where the fixture backplate meets the
exterior wall surface upward. Proceed to seal over
top of backplate and down other side.
NOTE: Do not seal bottom of fixture backplate to
ensure proper moisture drainage.
Lowes.com/allenandroth
B
D
C
C
E
F
CC
DD
CC