Installation Guide

Step 4. Secure the Head Rail
Place the head rail on the brackets as described in Step 3 above, and lock
in place. Check carefully to assure that each bracket is properly secured.
Step 5. Attach the Handle
Attach the handle to the bottom rail as illustrated. The handle is designed
to minimize contact with the shade's fabric. Always raise and lower the
shade SLOWLY to assure that the pleated fabric stacks neatly.
To lower the shade: grip the bottom-rail/handle and slowly pull straight down.
To raise the shade: put your hand(s) under the bottom rail (palm facing up) and
lift slowly until the desired height is reached.
Step 6. Install the Hold-Down Brackets
Hold-down brackets are provided for optional use and are typically used on
doors with windows such as French doors. These brackets are intended to be
used only if the shade is to be in a permanently lowered position. With the shade
fully lowered, make pencil marks at the outside ends of the bottom rail. Brackets
should be lined up to the pencil marks and screwed into place using the 3/8-inch
screws. Insert the pins protruding from the brackets in the holes on both ends of
the bottom rail (see illustration).
CLEANING INSTRUCTIONS
The vinyl head rail and bottom rail can be wiped clean with a damp sponge. To
clean the shade's fabric, use a feather duster or vacuum lightly using a soft
brush attachment.
To remove wrinkles or creases, steam the front of the shade on a light setting.
Do not iron.
3