User Manual Kennilton 36in Vanity

1a. Open the preassembled drawer as far as possible.

1b. Simultaneously press the right side spring clip downward and the left side

spring clip upward.

1c. Once both springs clips are held in the indicated position, pull the drawer

straight out.

2a. In case of uneven oors, oor levelers are provided at the bottom of the

vanity. If necessary, adjust oor levelers by hand to correct tilting and/or

level doors.

ASSEMBLY INSTRUCTIONS

Step 1: Vanity Drawer Removal

Step 2: Adjustable Level

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble or install the product.

WARNING

CAUTION

Do not stand on vanity. Use vanity on level ground. Base vanity supports a maximum weight of 200 lbs. Exceeding maximum

weight limit will compromise the integrity of the vanity structure and could cause the vanity to fail.

Do not hang from the vanity.

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware

contents list. If any part is missing or damaged, do not attempt to assemble the product.

Estimated Assembly Time: 15 minutes

Tools Required (not included): Silicone compound.

PACKAGE CONTENTS

x 1

HARDWARE CONTENTS (not shown actual size)

Touch-up Pen

PART DESCRIPTION QUANTITY

A Vanity Top (preassembled) 1

B Vanity Base 1

C Backsplash 1

Silicone

3a. To mount the backsplash (C) to the wall, apply a thin bead of silicone

compound (not included) to the unpolished back side and bottom of the

backsplash (C). Position backsplash (C) as shown onto vanity top (A)

and against the wall. Clean any excess silicone compound before allow-

ing to dry.

Step 3: Backsplash Installation