Instructions / Assembly

1. Install female hinges on gate frame using nuts and bolts. Nuts to be installed on the
inside of the enclosure. Hold gate and mark the locaon of male hinges.
2. Install male hinges to gate post. Point the male hinge on the boom up and the one
on top down.
3. Place gate on boom hinge and lower top male hinge into female hinge.
4. Test swing the gate and adjust as needed. Tighten all hinge bolts.
5. Aach gate fork latch at a convenient height.5. Aach gate fork latch at a convenient height.
Install Chain-Link Fabric
Install Chain-Link Fabric
1. Unroll chain-link fabric on the ground along the outside of the fence. Slide a tension
bar through the first row of chain link diamonds. Fasten tension bands (evenly placed
on terminal post) to the tension bar with carriage bolts’ heads to the outside of the fence.
2. Stretch the Fabric. Temporarily insert a tension bar a couple of feet from the unaached
end of fabric. Pull the tension bar to stretch the fabric unl it only allows a slight amount
of give when squeezed by hand.
3. Remove the excess fabric with pliers by opening the top and boom loops of a single 3. Remove the excess fabric with pliers by opening the top and boom loops of a single
strand of wire. Unwind the strand up through the links unl the fabric comes apart.
4. Insert a tension bar at the end of the fabric and connect to tension bands on terminal post.
5. Fasten the fabric securely to line posts and top rail with e wire.
- 4 -