User's Guide
Table Of Contents
- Regularity Notices and Conformity
- Antenna Warning
- Product Safety Notices
- Important
- 1.0 The NX Series
- 2.0 Preparation for Use
- 3.0 Care and Maintenance
- 4.0 Connections
- 5.0 Power
- 6.0 Connection interface
- 7.0 RM4/Sync Module Diagnostics
- 8.0 Tag Manager
- 9.0 Tag Read Actions
- 10.0 Tag Filters
- 11.0 Alerts
- 12.0 Storing Tags
- 13.0 Sending Tags
- 14.0 NX Series Reader Specifiactions
Allflex NX Series Operational Manual
Page 13 of 14
8.0 TAG MANAGER
Tag Manager is an all in one Tag Management program for Allflex Readers. The software supports
tag session reading, writing and deleting. Some readers are also configurable through the software.
To get Tag Manager vist http://www.aleis.com/aleis-software-user-guides/tag-manager. Once
downloaded be sure to check for updates through Help, Check for updates. To read more about Tag
Manager, a user guide can also be found in the link provided above.
9.0 TAG READ ACTIONS
There are four main actions that are preformed on a tag read. These include filtering, alerts, sending
and storing.
Each action can be configured through Menu -> Read Setup page.
10.0 TAG FILTERS
When a tag is read, it is first put through a tag filter. This can be configured to Ignore HDX or FDX
tags as well as ignore animal or Industry tags. If a tag doesn't pass a filter it is completely ignored
by the reader and will not cause alerts, sending or storing.
11.0 ALERTS
Audio or visual alerts can be configured for tag reads and errors.
12.0 STORING TAGS
Through the Memory menu option, you can configure when to store a tag, whether to ignore
duplicates and a few more options.
13.0 SENDING TAGS
When a tag is read, you can configure the reader to send the tag out through USB-PC, USB Drive,
Serial and Bluetooth.