Installation Instructions

Product Name: Network Gateway
Model Numbers: 204145 and 204531
Changes or modifications not expressly approved by the party re-
sponsible for compliance could void the user's authority to oper-
ate the equipment. This equipment has been tested and found to
comply with the limits for a Class B digital device pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technican for
help.
CAN ICES-3 (B) This device contains licence-exempt transmit-
ter(s)/receiver(s) that comply with Innovation, Science and Eco-
nomic Canada's licence-exempt RSS(s). Operation is subject to
the following two conditions: (1) this device may not cause inter-
ference, and (2) this device must accept any interference, includ-
ing interference that may cause undesired operation of the device.
This equipment complies with FCC/IC RSS-102 radiation expo-
sure limits set forth for an uncontrolled environment. This equip-
ment should be installed and operated with minimum distance
20cm between the radiator & your body.
This device complies with Part 15 of the FCC Rules.Operation
of this equipment or device is subject to the following
two
conditions: (1) this device may not cause harmful interfer-ence,
and (2) this equipment or device must accept any interfer-ence,
including interference that may cause undesired operation of the
device.
This product is certified by ANATEL according to the regulatory
procedures established by Motion No 242/2000, and it meets the
applicable technical requirements. This equipment is not author-
ized to protection against disruptive interference e cannot cause
interference in systems properly authorized. For more informa-
tion, see the ANATEL website www.anatel.gov.br.
Important Instructions
Subject: Speed Queen Insights Network Setup
Use With:
Speed Queen Insights
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
1 Form No. 9-17-348ENR3
May 2019

Summary of content (14 pages)