Tumble Dryer Installation/Operation Maintenance Manual

18 M414545

POSITIONING THE TUMBLER

The tumbler may be removed from the skid before

moving it to the installation location or it may be moved

while still attached to the skid. To remove tumbler from

the skid, unscrew the four shipping capscrews (one at

each corner) and remove the tumbler from the skid. The

lint panel door will have to be removed in order to remove

the two front capscrews.

NOTE: Do not throw these four capscrews away —

they are the leveling legs.

Screw the four leveling legs back into the level adjusting

fittings from the top.

Slide the tumbler to its permanent location and level.

Keep the tumbler as close to the floor as possible. The

tumbler must rest firmly on the floor so weight of tumbler

is evenly distributed. Tumbler must not rock.

LEVELING THE TUMBLER

Each tumbler should be leveled within 1/8 inch (3.2 cm)

from front to rear, and 1/8 inch (3.2 cm) from side to side.

Check front to rear level by rotating the clothes cylinder

until one rib is at the bottom, then place a level on the rib.

Side to side level should be checked by placing a level on

the front and rear of the top panel.