Tumble Dryer Installation/Operation Maintenance Manual

38 M414545

FINAL OPERATING CHECKS

OPL MICRO CONTROL TUMBLER

Refer to OPL micro-control section to check control for

proper operation.

MANUAL DUAL TIMER TUMBLER

Refer to Figure 13.

1. Set the TEMPERATURE selector to the desired

temperature, and set the DRYING and COOLING

selectors to maximum.

2. Press the PUSH-TO-START button in and hold it in

for approximately three seconds. The motor will

start, the heat system will come on and the DRYING

indicator will light.

3. During the drying period the DRYING selector

rotates counterclockwise. When the DRYING

selector reaches “0” the heat system will shut off, the

DRYING indicator will go out and the COOLING

indicator will light.

During the cooling period the COOLING selector rotates

to the left. When the COOLING selector reaches “0” the

motor will stop and the COOLING indicator will go out

indicating the end of the cycle.

COIN-OPERATED TUMBLER

Refer to Figure 14.

1. Set the TEMPERATURE selector to the desired

temperature.

2. Insert required number of coins in the coin slot and

turn the knob fully clockwise and release it. The

RUN indicator (option) will light.

For Coin Slide Models — Place required number of

coins in coin slide and push slide in as far as possible,

then release.

3. Press the PUSH-TO-START button in and hold it in

for approximately three seconds. The motor will start

and the heat circuit will come on.

4. An automatic preset 2-1/2 minute cool-down period

occurs near the end of the cycle. During this period

the heat system is off and encompassing air circulates

through the load to cool it.

5. When the coin metered time expires, the cycle is

completed.